FIR FLY WHEEL PULLER 55mm x 1mm

FLY WHEEL PULLER 55mm x 1mm RH. DUCATI It fits Ducati 200/250/350 and most narrow-case bevel single models. HOLDER O.D.: 62MM, Thread I.D.: 55mm, LENGTH: 79MM.
BOLT: 1/2" X 12UNC, LENGTH: 93MM, SIDE TO SIDE: 19MM. Hard black oxide finish. The only way to remove that flywheel unless you're a hammer-toting, knuckle-dragging mouth-breather This professional puller should be in the toolbox of every owner of Ducati singles. The new design has a replaceable brass bushing at the contact point, and it should fit all later wide-case machines. NOTE.
Please check the thread size of your motor before ordering Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel. [FACTORY IMAGE RACING] (Distributed ) Cross Reference Numbers Only:
UP-12231-1, 88713-0250