K&L Supply FLYWHEEL PULLER BOLT 14mm x 1.5mm

PRODUCT INFORMATION




More Information


Brand
K&L Supply


Size
14mmx1.50mm


Product Type
Brake & Clutch Tools


Product Group
Workshop Tools & Equipment


Catalogue
ROAD, TOOLS






VEHICLE FITMENT


No active finders or options.

DESCRIPTION

14mm x 1.50 Flywheel Puller STUD RH Male, Magneto K&L 00-0829 HONDA
Honda ATC200 1981 - 1985
Honda ATC200E 1981 - 2004
Honda ATC200M 1984 - 1985
Honda ATC200S 1984 - 1986
Honda ATC200X 1981 - 2011
Honda CB125S 1973 - 1985
Honda TRX125 1985 - 1988
Honda TRX200 1984
Honda XL125 1970 - 1983
Honda XL125S 1979 - 1985
Honda XL185S 1979 - 1983
Honda XL200R 1983 - 1984
Honda XR185 1979
Honda XR200 1980 - 1984
Honda XR200R 1980 - 2003 All pullers made to precise standards equal to factory original tools or better. Each tool and bolts are black oxide plated for rust protection. Tool hardness is softer than the motorcycle part to prevent damage to expensive crankshafts and flywheels. 5/8in. fine thread bolts used in all pullers. Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel. Part No. 00-092 (oro2u.com). Cross Reference Numbers Only:
MP19

14mm x 1.50 Flywheel Puller STUD RH Male, Magneto K&L 00-0829 HONDA
Honda ATC200 1981 - 1985
Honda ATC200E 1981 - 2004
Honda ATC200M 1984 - 1985
Honda ATC200S 1984 - 1986
Honda ATC200X 1981 - 2011
Honda CB125S 1973 - 1985
Honda TRX125 1985 - 1988
Honda TRX200 1984
Honda XL125 1970 - 1983
Honda XL125S 1979 - 1985
Honda XL185S 1979 - 1983
Honda XL200R 1983 - 1984
Honda XR185 1979
Honda XR200 1980 - 1984
Honda XR200R 1980 - 2003 All pullers made to precise standards equal to factory original tools or better. Each tool and bolts are black oxide plated for rust protection. Tool hardness is softer than the motorcycle part to prevent damage to expensive crankshafts and flywheels. 5/8in. fine thread bolts used in all pullers. Tips on use.
- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.
- Use copper grease on the puller threads, for long life.
- Make sure the puller is fully screwed into the flywheel.
- After tightening use a hammer on the centre and tap to jolt free [not always need].
- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel. Part No. 00-092 (oro2u.com). Cross Reference Numbers Only:
MP19


SHOW MORE